How to operate the power line dedicated salt spray box?

How to operate the power line dedicated salt spray box? In the last few days, some users have received phone calls and asked how to operate the equipment. Since the user just bought the equipment, it is not very familiar with the operation steps. Therefore, we consult with us. Next, Haida technicians share this section for you. Equipment operation method :

1 , set the required test time, test time digital tube and the middle of the value of the decrease, increase the corresponding adjustment.

2 , according to the power switch, set the test temperature and saturation temperature value, the time is set in the power before turning on the power, or will lose control.

3. There is a certain relationship between the setting value of the saturated bucket temperature and the spray pressure. The temperature is as follows when the pressure is different:

1 ) Test temperature 35 °C Spray pressure MPa 0.07 0.08 0.09 0.1 Note : For reference only

2 ) Air temperature °C 36 37 38 39

4 , the preparation of saline solution:

1 ) Prepare 5% salt solution using sodium chloride and distilled water. The collected liquid after atomization cannot be reused.

2) may be the PH value PH test paper or pH meter amount, when the previous 35 deg.] C PH value should be in the range of 6.6 to 7.2.

3 ) If the measured pH is not within this range, adjust with dilute hydrochloric acid or sodium hydroxide. Do not use concentrated hydrochloric acid or solid sodium hydroxide directly into the salt solution to prevent local concentration and affect the measurement of PH value.

5 , spray selection has continuous and periodic, the panel on the switch to the new continuous gear stalls, you can spray test, if you need to spray gap, set its stop and spray time, respectively, and then the switch on the panel New to the cycle, the cycle test can begin.

6 , after the end of the test, should be the first row of fog, open the switch for two minutes, the fog can be discharged to avoid salt spray in the opening of the test room when distributed to affect other equipment.

7. Turn off the power supply and unscrew the flat constant mist outlet at the bottom. Clean the equipment. Do not wipe the operation panel with the water towel to prevent water from entering.