What are the requirements for entering a clean and dust-free workshop?
What are the requirements for entering a clean, dust-free workshop?
The average person may not know much about the requirements of the clean and dust-free workshop. In the past few days, I was fortunate to go to Wuxi to install the air shower room with a predecessor of the company. I didn't understand it before. After I went there, I learned about the installation of the air shower room. ,Specific requirements are as follows:
1. At the first door, a piece of blue adhesive tape is placed on the floor, stepped on to stick the contents of the sole, then take off the shoes and walk in the hand, then put the shoes in the designated personal shoe cabinet. . At this time, the shoes are not the shoes we usually wear, but the shoes that are immediately replaced after entering the workshop. Work shoes are basically not brought out of the workshop.
2. After storing the shoes, go to the door of the air shower room and pick up the prepared small black cloth pieces. After a few steps on the face, follow the prescribed steps and enter the air shower room where the wind turns and the wind blows like a group of magical dances. .
3. Out of the air shower room, you have to take the water to wet the paper to wipe the face according to the prescribed steps, you must wear glasses to wear glasses.
4. Enter the dressing section below.
(1) First take the hair net to ensure that all hair is in the hair net, and the ears have to go in;
(2) Then the purifying cap, with the back of the head, only the eyes are exposed, and other parts are covered, saying that it is a hat, in fact, the upper body is almost covered;
(3) Then put on the cleansing suit that is attached to the upper body and the lower body.
(4) There are also purifying shoes, like boots.
(5) When you are finished wearing rubber gloves, you must put the glove's mouth over the first cuff of the sleeve and pull the second layer of the sleeve to the outside of the glove.
5. Then wash your hands and wash your hands with gloves.
6. After washing, it must be dried to enter another air shower room, and the air shower time is required to be no less than 28 seconds.
SW-CJ-1Cu double single-sided purification workbench
The horizontal one-way manifold purification workbench is a versatile local purification equipment, which is widely used in electronics, national defense, precision instruments, instruments, pharmaceuticals and other industries.
Characteristics
1, horizontal popular, quasi-closed glass damper, easy to operate.
2, using remote control switch fast two-speed control fan system to ensure that the wind speed in the work area is in an ideal state
3, using ultra-thin aluminum frame without partition high-efficiency air filter, the size of the static pressure box is reduced to a minimum, reducing the size of the cabinet shell, increasing the area of ​​the clean area
Technical Parameters
model
SW-CJ-1Cu
Cleanliness
Level 100 @≥0.5μm (US Federal 209E)
Number of colonies
<0.5 pcs/dish. (diameter 90mm culture plate)
noise
≤62dB(A)
average wind speed
0.25-0.45m/s
Vibration half-peak
≤0.5μm (X·Y·Z)
Illuminance
≥300LX
power supply
AC, single phase 220V/50HZ
Maximum power consumption
800W
weight
400KG
Working size
1770*500*600mm
Dimensions
1820*745*1620mm
High efficiency filter specifications and quantities
1675*600*38*1
Fluorescent / UV lamp specifications and quantities
30W*1/30W*1
Ice Bucket Glass,Crystal Ice Bucket,Glass Bucket,Crystal Champagne Bucket
Xi`an ATO International Co., Ltd , https://www.ato-group.com